Readme

Collapse
No announcement yet.

Dash lights does not illuminate

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dash lights does not illuminate

    Cant see dash at night. Warning light illuminate.
    The set up im running is a rhd xsi harness 93 da6 i am running a usa cluster would that make it not illuminate bc im not running the jdm cluster.

  • #2
    Was wondering if i can set up the dimmer switch to the rhd harness and how would i do that

    Comment


    • #3
      The USDM and JDM clusters are the same wiring connections. The only difference between clusters is if one had cruise control and the other did not. I'm pretty sure the illumination wire for the cluster is red / black stripe / 1 silver band. Jdm harness should have a dimmer switch also. If you don't have a dimmer switch, that is your problem. The lights on wire runs through the switch then to the cluster. If the switch is missing, the circuit is broken.
      Last edited by 2ndJenn; 21 Aug 2016, 22:48:11.

      Comment


      • #4
        Ok. The rhd clip that i bought from hmo didnt come with a dimmer connector doesnt look like it was cit or any juat not equipped there is one connector that is just hanging there. Dont know what connects to it. Ive been trying to find a picture of what goes there

        Comment


        • #5
          Let me work on getting the wire color codes for you.

          Comment


          • #6
            Thanks 2ndjen

            Comment


            • #7
              Out of all the switches I have ( which is a shit load) , the only one I don't have a pig tail for is the dimmer! It is a small three wire plug about 3/4 inches wide. Same female plug as the power mirror harness behind the door panel. If you can wait until tomorrow I will pull the switch on my car and get you the color codes.

              Comment


              • #8
                I can wait after all its been 3 years off (had a kid) and on but im trying to get this thing ready for the road. How can i post pictures on here. Sorry noob question new to this forum. So i can show you what connector i have
                Last edited by Da6_Jabo; 22 Aug 2016, 00:24:19. Reason: Misspelled

                Comment


                • #9
                  1. red / black stripe / silver band
                  2. Black / silver band
                  3. Red / silver band

                  Left to right from the back of the plug with the clip facing up.
                  1 is lights to cluster
                  2 is ground (need to verify)
                  3 is lights input

                  You can text me
                  Last edited by 2ndJenn; 22 Aug 2016, 01:51:20.

                  Comment


                  • #10
                    Can

                    Comment


                    • #11
                      Ok. Sent them to you

                      Comment

                      Working...
                      X